Pipelines & drainage

Mains and drainage, laid across the country.

The pipelines team carries out directional drilling, pipe bursting, slip lining and open-cut mains and drainage. The work is for clients who need a length of main or a drainage run completed, tested and left in a state they can accept.

Methods

We use the method the ground and the existing network allow, not a single technique for every street.

Directional drilling

Horizontal directional drilling where a main has to pass under an obstacle without opening the full length.

Pipe bursting

Replacing an existing pipe on its line by bursting it and pulling the new main through.

Slip lining

A new pipe inserted inside a host pipe, where the diameter and the route allow it.

Open cut

Traditional open-cut laying for mains and drainage where access, depth and the surroundings suit it.

Pressure testing

Testing is part of finishing a main, so the client receives a length that has been proved, not just laid.

Questions contractors ask

Do you cover sites outside the West Midlands?

Yes. Pipelines and drainage are provided nationwide. Enquiries still come through the Halesowen office.

Can trenchless and open-cut work sit on the same package?

Yes. Directional drilling, pipe bursting, slip lining and open cut are all part of the same team, so a package can mix them.

Who is the work for?

Contractors and utilities clients in the water sector, and drainage that sits alongside housebuilding civils.

Tell us about the package.

A short note on the site, the programme and the trade you need is enough to start.

Contact the team